Your water heater is one of the most used and more appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving from the home heating and costs.
Regular flushing of your water heater is among the single most important step you consider to prolong its service life and to save energy. During time, sediments strengthen in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regions of the country, the common water heater lasts 3-5 years. Regularly flushing your hot water heater can double lifestyle of your hot water heater from 3-5 to 7-10 years. And with the costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is a must in today’s markets. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a week.
To drain your water heater, initially you should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located in the water inlet line going into your water heater. Equipped to connect a hose to the drain valve located towards the end of the space heater. Open the drain and allow it to play until all of the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the hot water heater. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until the actual flows out gradually. This will allow air to vent inside heater and the hot water lines. Finally, you can turn the thermostat for you to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so is certainly less corrosive to your plumbing system, particularly in areas possess hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your area to discuss options and merchandise to provide what you need.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX